The following are the three steps to cloning marijuana. Everything is so simple. If you have questions about cloning, need help, or want to learn more about this topic you can check various online sites.
Step1:
Remember that even though the center is fully extended, it might still be dry. It is important to let them soak a minute or two after they expand. To get marijuana clones you can also visit https://mendobros.com/.
If you are not sure, it's good to open the peat and reach the top. Once you are sure they are really wet, you should press it lightly. Just like a full marijuana plant does not want to be soaked, cutting does not want to sit in a swamp. Don't do it here.
Image Source: Google
Step2:
Now all you have to do is take off the lower fan blades, cut the bottom of the stem at an angle of about 45 °, and make a cut in a glass of water. You know I won't let you hold on "why is that," so let me explain.
Remember that cannabis plants are hard. Fortunately, you only use straight cuts to pull branches out of the main stem.
You take the leaves because you will bury this part of the stem. Cutting corners create a larger surface which makes it easier to absorb water. When you finally put your cutter in the water, no air can get into the handle.
Step3:
You can delete everything except the first two fans of all my cuttings. This creates space in the dome and cuts less to stay alive until the roots are formed.
From now on, you only need to give a little fog clone for one or two days. It's time to put it in your container. So, this is a cloning guide.